ALBERTSON SCHOOL OF MUSIC is a renovation/alteration project at 12918 SHOPS PKWY, #550, Bee Cave, in Travis County, TX, tracked from its Texas Department of Licensing and Regulation (TDLR) registration. Construction complete (TDLR inspection passed Feb 2009). The project has an estimated value of $75K.
Project has been completed and closed
ALBERTSON SCHOOL OF MUSIC is a Renovation/Alteration project located at 12918 SHOPS PKWY, #550, Bee Cave, TX 78738 in Bee Cave, Texas. The project has an estimated value of $75K. CHRISTOPHER COMMERCIAL is the property owner and O'BRIEN & ASSOCIATES INC is the design firm of record. The project was registered with TDLR on December 19, 2008.
ALBERTSON SCHOOL OF MUSIC is a renovation/alteration project at 12918 SHOPS PKWY, #550 in Bee Cave, Texas, registered with the Texas Department of Licensing and Regulation (TDLR). Scope of work: Interior finish out
Construction on ALBERTSON SCHOOL OF MUSIC is complete — TDLR records show the project passed its required accessibility inspection in Feb 2009. The building is finished and very likely open.
ALBERTSON SCHOOL OF MUSIC is located at 12918 SHOPS PKWY, #550, Bee Cave, TX, 78738, in Travis County.
CHRISTOPHER COMMERCIAL is the property owner/developer of record for ALBERTSON SCHOOL OF MUSIC, per its TDLR project registration.
O'BRIEN & ASSOCIATES INC is the design firm of record for ALBERTSON SCHOOL OF MUSIC, according to its TDLR filing.
ALBERTSON SCHOOL OF MUSIC has an estimated construction value of $75K, based on its TDLR filing.
Interior finish out
Note: This project is registered under the Texas Accessibility Standards (TAS) program. TDLR registration is required for commercial and public facility construction to ensure compliance with accessibility requirements under Texas Government Code Chapter 469.
Filed
Dec 19, 2008
Review Complete
Inspection Complete
Closed
Feb 1, 2009
Building permits found at or near this location
Electric work The service being upgraded is suite #300B. We are taking out wire panel A and B ( before 100 Amp for each ) and then running the EMT 2 conduit from the disconnect to the meter base Suite # 300B then to the 480V pane
Electrical work I have removed all the wires in the 300 As conduit the 300 A electric meter is no longer available. We installed 3/0 wire for the 300 B electric meter. Previously 300A and 300B were 2 separate shops the electricity meter was 100 amp each side I took all the wires from the 300 A meter inside the shop. we installed disconnect 200 amp plus pre-existing electric meter 300B
Replacement of an existing water heater ETJ
Replace burned meter socket to existing commerical. EUD. Permit required per Austin Energy.
Change out hvac system to res only.
