A1726301 - TEN-X INTERIOR RENOVATION
A1726301 - TEN-X INTERIOR RENOVATION is a renovation/alteration project at 8300 N. CAPITAL OF TEXAS HWY. Suite 300, Austin, in Travis County, TX, tracked from its Texas Department of Licensing and Regulation (TDLR) registration. Currently under construction. The project has an estimated value of $543K.
📊Project Metrics
TDLR #EABPRJB8800290Project Registered
Project has been registered with TDLR and is in pre-construction phase
A1726301 - TEN-X INTERIOR RENOVATION is a Renovation/Alteration project located at 8300 N. CAPITAL OF TEXAS HWY. Suite 300, Austin, TX 78759 in Austin, Texas. The project has an estimated value of $543K. DWF IV PARK LP is the property owner and CARSON DESIGN ASSOCIATES is the design firm of record. The project was registered with TDLR on September 7, 2017.
❓Frequently Asked Questions
What is A1726301 - TEN-X INTERIOR RENOVATION?
A1726301 - TEN-X INTERIOR RENOVATION is a renovation/alteration project at 8300 N. CAPITAL OF TEXAS HWY. Suite 300 in Austin, Texas, registered with the Texas Department of Licensing and Regulation (TDLR). Scope of work: This project consists of the demolition and finish out of an existing demised tenant suite. Suite occupancy clas
Is A1726301 - TEN-X INTERIOR RENOVATION open in Austin?
A1726301 - TEN-X INTERIOR RENOVATION is currently under construction in Austin, TX. Its current TDLR status is "Project Registered".
Where is A1726301 - TEN-X INTERIOR RENOVATION located?
A1726301 - TEN-X INTERIOR RENOVATION is located at 8300 N. CAPITAL OF TEXAS HWY. Suite 300, Austin, TX, 78759, in Travis County.
Who is the owner or developer of A1726301 - TEN-X INTERIOR RENOVATION?
DWF IV PARK LP is the property owner/developer of record for A1726301 - TEN-X INTERIOR RENOVATION, per its TDLR project registration.
Who is the architect or design firm for A1726301 - TEN-X INTERIOR RENOVATION?
CARSON DESIGN ASSOCIATES is the design firm of record for A1726301 - TEN-X INTERIOR RENOVATION, according to its TDLR filing.
How much does A1726301 - TEN-X INTERIOR RENOVATION cost and how big is it?
A1726301 - TEN-X INTERIOR RENOVATION has an estimated construction value of $543K, based on its TDLR filing.
📋Scope of Work
This project consists of the demolition and finish out of an existing demised tenant suite. Suite occupancy clas
Note: This project is registered under the Texas Accessibility Standards (TAS) program. TDLR registration is required for commercial and public facility construction to ensure compliance with accessibility requirements under Texas Government Code Chapter 469.
📅Compliance Timeline
📅Project Timeline
Filed
Sep 7, 2017
Review Complete
Inspection Complete
Closed
🔗Related Projects
📄Related City Permits
Building permits found at or near this location
Replacement of complete existing central heat and air system with or without duct work Replacement of HVAC system.
Replacement of complete existing central heat and air system with or without duct work
EXPRESS: Foundation repair
Addition of a rear patio cover - minor electrical
PROJECT SCOPE Provide one new dedicated AFCI/GFCI protected 20A 120V branch circuit from the main panel on the exterior wall of the house to a new kitchen range hood. No meter work being performed. INSTALLATION DETAILS Install a vertical 1-inch Steel EMT raceway exiting the main electrical panel from a 1-inch LR conduit body (located below all energized parts) on the homes exterior brick wall. Transition raceway to horizontal orientation for building penetration using a 1 LB. Penetrate into the accessible attic with 1 EMT terminating into a 4-11/16 steel junction box with a blank cover. Install #10-2 UF-B cable (1 HOT 1 NEUTRAL 1 EGC) (Sunlight Resistant/Wet Location rated) from the range hood to the steel junction box. Cable will be routed along ceiling rafters; any portion below 7 will be protected by guard strips per NEC 320.23. The #10-2 UF-B will be sleeved continuously from the 4-11/16 junction box through the LB down the vertical EMT and through the LR terminating directly into the main panel . This avoids all splices providing a continuous run from the OCPD to the appliance. CODE COMPLIANCE NOTES: 10 AWG conductors are specd. for this 20A circuit to account for ambient temperature correction in the unconditioned attic and sun-exposed exterior raceway. The EMT will be sealed with duct seal at the attic box and panel entry to prevent moisture migration and condensation per NEC 300.7. All cables and raceways will be supported/secured per NEC. All exterior fittings/hardware will be UL-listed rain-tight compression type. All cables and raceways will be supported and secured per NEC requirements. An insulated throat fitting or plastic bushing will be used at all EMT entry points to protect the cable jacket from abrasion. All wire terminations will be torqued to the manufacturer specifications per 2023 NEC 110.14(D)