Under construction📋Project Registered🏗️ New Construction💵 This project is privately funded, on private land for private use.

MS Calibration WS

3335 Pollok Dr, Conroe, TX 77303, Conroe, TX, 77303

MS Calibration WS is a new construction project at 3335 Pollok Dr, Conroe, in Montgomery County, TX, tracked from its Texas Department of Licensing and Regulation (TDLR) registration. Currently under construction. The project has an estimated value of $95K across about 324 sq ft.

Pre-Construction15%

📊Project Metrics

TDLR #TABS2021022318

$95K

Project Value

324

Square Feet

$293/sqft

Cost/SqFt

3 months

Duration

Registered:Aug 17, 2021

Start:Sep 1, 2021

Target:Dec 1, 2021

📋

Project Registered

Project has been registered with TDLR and is in pre-construction phase

MS Calibration WS is a New Construction project located at 3335 Pollok Dr, Conroe, TX 77303 in Conroe, Texas. The project has an estimated value of $95K covering 324 sq ft. CLAY #6 3335 POLLOK LLC is the property owner and Lone Star Engineering & Inspections is the design firm of record. The project was registered with TDLR on August 17, 2021.

❓Frequently Asked Questions

What is MS Calibration WS?

MS Calibration WS is a new construction project at 3335 Pollok Dr in Conroe, Texas, registered with the Texas Department of Licensing and Regulation (TDLR). Scope of work: proposed new 18'x18' workshop for calibration of equipment w/ single workstation

Is MS Calibration WS open in Conroe?

MS Calibration WS is currently under construction in Conroe, TX. Its current TDLR status is "Project Registered".

Where is MS Calibration WS located?

MS Calibration WS is located at 3335 Pollok Dr, Conroe, TX, 77303, in Montgomery County.

Who is the owner or developer of MS Calibration WS?

CLAY #6 3335 POLLOK LLC is the property owner/developer of record for MS Calibration WS, per its TDLR project registration.

Who is the architect or design firm for MS Calibration WS?

Lone Star Engineering & Inspections is the design firm of record for MS Calibration WS, according to its TDLR filing.

How much does MS Calibration WS cost and how big is it?

MS Calibration WS has an estimated construction value of $95K and approximately 324 square feet (about $293/sqft), based on its TDLR filing.

📋Scope of Work

proposed new 18'x18' workshop for calibration of equipment w/ single workstation

Note: This project is registered under the Texas Accessibility Standards (TAS) program. TDLR registration is required for commercial and public facility construction to ensure compliance with accessibility requirements under Texas Government Code Chapter 469.