Design review complete, construction may proceed
United Airlines Lobby Refresh is a Renovation/Alteration project located at 3600 Presidential Blvd., Austin, TX 78719 in Austin, Texas. The project has an estimated value of $95K covering 1,082 sq ft. City of Austin is the property owner and Gensler is the design firm of record. The project was registered with TDLR on December 17, 2021.
Project consists of renovation of existing level 03 concourse level United Airlines ticketing lobby, including new ticket counters and freestanding kiosks.
Note: This project is registered under the Texas Accessibility Standards (TAS) program. TDLR registration is required for commercial and public facility construction to ensure compliance with accessibility requirements under Texas Government Code Chapter 469.
Filed
Dec 17, 2021
Review Complete
Dec 17, 2021
Inspection Complete
Closed
Building permits found at or near this location
Remodel of existing office spaces for tenant who is expanding into adjacent suites. Access control requested.
Construction of structural towers attached to main terminal building stairwells and light poles to allow camera installation for Virtual Ramp Control System. Work proposed in electrical rooms IT rooms etc. with new conduits/circuits (power and signal) being run from those rooms. Mechanical work proposes installation of compressor systems that go with the camera houses. These are dedicated systems that SAAB maintains and do not connect to any HVAC or other airport mechanical systems. Infrastructure (electrical =mechanical) for powering and maintaining camera systems. [Airside Permits]
Construction of structural towers attached to main terminal building stairwells and light poles to allow camera installation for Virtual Ramp Control System. Work proposed in electrical rooms IT rooms etc. with new conduits/circuits (power and signal) being run from those rooms. Mechanical work proposes installation of compressor systems that go with the camera houses. These are dedicated systems that SAAB maintains and do not connect to any HVAC or other airport mechanical systems. Infrastructure (electrical =mechanical) for powering and maintaining camera systems. [Airside Permits]
Construction of structural towers attached to main terminal building stairwells and light poles to allow camera installation for Virtual Ramp Control System. Work proposed in electrical rooms IT rooms etc. with new conduits/circuits (power and signal) being run from those rooms. Mechanical work proposes installation of compressor systems that go with the camera houses. These are dedicated systems that SAAB maintains and do not connect to any HVAC or other airport mechanical systems. Infrastructure (electrical =mechanical) for powering and maintaining camera systems. [Airside Permits]
Interior renovations with an existing building for virtual ramp control system improvements. Electrical and communications work proposed (3011 Employee Ave). [Landside Permits]
