Final inspection completed, awaiting project closure
Add Four Offices to 2.150 (BEG CP2000250) is a Renovation/Alteration project located at 10100 Burnet Road, Austin, TX 78758 in Austin, Texas. The project has an estimated value of $329K covering 5,000 sq ft. The University of Texas at Austin is the property owner and Jacobs is the design firm of record. The project was registered with TDLR on April 21, 2026.
Add Four Offices to 2.150 (BEG CP2000250) is a renovation/alteration project at 10100 Burnet Road, Austin, TX 78758 in Austin, Texas, registered with the Texas Department of Licensing and Regulation (TDLR). Scope of work: Add four offices to open area 2.150 (Project BEG CP2000250)
Construction on Add Four Offices to 2.150 (BEG CP2000250) is complete — TDLR records show the project passed its required accessibility inspection in Apr 2026. The building is finished and very likely open.
Add Four Offices to 2.150 (BEG CP2000250) is located at 10100 Burnet Road, Austin, TX 78758, Austin, TX, 78758, in Travis County.
The University of Texas at Austin is the property owner/developer of record for Add Four Offices to 2.150 (BEG CP2000250), per its TDLR project registration.
Jacobs is the design firm of record for Add Four Offices to 2.150 (BEG CP2000250), according to its TDLR filing.
Add Four Offices to 2.150 (BEG CP2000250) has an estimated construction value of $329K and approximately 5,000 square feet (about $66/sqft), based on its TDLR filing.
Add four offices to open area 2.150 (Project BEG CP2000250)
Note: This project is registered under the Texas Accessibility Standards (TAS) program. TDLR registration is required for commercial and public facility construction to ensure compliance with accessibility requirements under Texas Government Code Chapter 469.
Filed
Apr 21, 2026
Review Complete
Inspection Complete
Apr 26, 2026
Closed
Building permits found at or near this location
Request to disconnect Add 125 amp main to existing panel Per EC: they will not be upgrading anything as the existing service can handle the addition of the 125 amp
Install new 9.20 kW DC rooftop solar system to existing residential
Install Inground Prefabricated Pool w/Spa ELECTRIC HEAT NO PP REQUIRED Concrete Decking Remove/Demo Existing Above Ground Pool and Wood Deck
Install Inground Prefabricated Pool w/Spa ELECTRIC HEAT NO PP REQUIRED Concrete Decking Remove/Demo Existing Above Ground Pool and Wood Deck
EV charger installation. install 60 AMP 240 Volt breaker in the main panel using an available slot. Route branch circuit directly behind the main panel and hard wire the GM power up 2 onto the interior side wall of the garage. The charger will be installed on a 60-amp circuit and will draw up to 48 amp continuous.
