Final inspection completed, awaiting project closure
NXP W&E Building UPS Infrastructure Install Design is a Additions to Existing Building project located at 6501 William Cannon Drive, Austin, TX 78735 in Austin, Texas. The project has an estimated value of $450K covering 3,000 sq ft. NXP is the property owner and Fuse Architecture Studio is the design firm of record. The project was registered with TDLR on November 10, 2022.
NXP W&E Building UPS Infrastructure Install Design is a additions to existing building project at 6501 William Cannon Drive, Austin, TX 78735 in Austin, Texas, registered with the Texas Department of Licensing and Regulation (TDLR). Scope of work: Expand DAIR capacity on BLDG-E, Level 2, Test Floor.
Construction on NXP W&E Building UPS Infrastructure Install Design is complete — TDLR records show the project passed its required accessibility inspection in Apr 2026. The building is finished and very likely open.
NXP W&E Building UPS Infrastructure Install Design is located at 6501 William Cannon Drive, Austin, TX 78735, Austin, TX, 78735, in Travis County.
NXP is the property owner/developer of record for NXP W&E Building UPS Infrastructure Install Design, per its TDLR project registration.
Fuse Architecture Studio is the design firm of record for NXP W&E Building UPS Infrastructure Install Design, according to its TDLR filing.
NXP W&E Building UPS Infrastructure Install Design has an estimated construction value of $450K and approximately 3,000 square feet (about $150/sqft), based on its TDLR filing.
Expand DAIR capacity on BLDG-E, Level 2, Test Floor.
Note: This project is registered under the Texas Accessibility Standards (TAS) program. TDLR registration is required for commercial and public facility construction to ensure compliance with accessibility requirements under Texas Government Code Chapter 469.
Filed
Nov 10, 2022
Review Complete
Nov 10, 2022
Inspection Complete
Apr 23, 2026
Closed
1260d
Construction phase
Building permits found at or near this location
Express: Replace siding on the back of home. The electrical permit is a child of the building permit.
Replacement of complete existing central heat and air system with or without duct work
Total demo of SFR 1483 sq ft circa 1960 ***The building shall not be demolished until after the contractor has fulfilled the neighbor notification requirements outlined in Steps 5 & 6 of the Demolition webpage.***
Upgrade residential main service from 200amps to 400amps (two 200amps panels 320A meter riser replacement to 3). Overhead drop not required to be replaced. AUSTIN 2 MILE ETJ
Total demo of SFR 1483 sq ft circa 1960 ***The building shall not be demolished until after the contractor has fulfilled the neighbor notification requirements outlined in Steps 5 & 6 of the Demolition webpage.***
