Under construction📝Review Complete🔧 Renovation/Alteration💵 This project is privately funded, on private land for private use.

SAS FAB1 Slurry Blender Demo

12100 Samsung Blvd, Austin, TX 78754, Austin, TX, 78754

SAS FAB1 Slurry Blender Demo is a renovation/alteration project at 12100 Samsung Blvd, Austin, in Travis County, TX, tracked from its Texas Department of Licensing and Regulation (TDLR) registration. Currently under construction. The project has an estimated value of $800K across about 1,660 sq ft.

Construction50%

📊Project Metrics

TDLR #TABS2026019994

$800K

Project Value

1,660

Square Feet

$482/sqft

Cost/SqFt

2 months

Duration

Registered:May 12, 2026

Start:May 15, 2026

Target:Jun 30, 2026

📝

Review Complete

Design review complete, construction may proceed

SAS FAB1 Slurry Blender Demo is a Renovation/Alteration project located at 12100 Samsung Blvd, Austin, TX 78754 in Austin, Texas. The project has an estimated value of $800K covering 1,660 sq ft. SAMSUNG AUSTIN SEMICONDUCTOR is the property owner and Fuse Architecture Studio is the design firm of record. The project was registered with TDLR on May 12, 2026.

❓Frequently Asked Questions

What is SAS FAB1 Slurry Blender Demo?

SAS FAB1 Slurry Blender Demo is a renovation/alteration project at 12100 Samsung Blvd in Austin, Texas, registered with the Texas Department of Licensing and Regulation (TDLR). Scope of work: Demolition of idle slurry equipment and distribution loops in FAB1 Slurry and unused VMB F1-ESC784-F6-01V-W in FAB1 CSF

Is SAS FAB1 Slurry Blender Demo open in Austin?

SAS FAB1 Slurry Blender Demo is currently under construction in Austin, TX. Its current TDLR status is "Review Complete".

Where is SAS FAB1 Slurry Blender Demo located?

SAS FAB1 Slurry Blender Demo is located at 12100 Samsung Blvd, Austin, TX, 78754, in Travis County.

Who is the owner or developer of SAS FAB1 Slurry Blender Demo?

SAMSUNG AUSTIN SEMICONDUCTOR is the property owner/developer of record for SAS FAB1 Slurry Blender Demo, per its TDLR project registration.

Who is the architect or design firm for SAS FAB1 Slurry Blender Demo?

Fuse Architecture Studio is the design firm of record for SAS FAB1 Slurry Blender Demo, according to its TDLR filing.

How much does SAS FAB1 Slurry Blender Demo cost and how big is it?

SAS FAB1 Slurry Blender Demo has an estimated construction value of $800K and approximately 1,660 square feet (about $482/sqft), based on its TDLR filing.

📋Scope of Work

Demolition of idle slurry equipment and distribution loops in FAB1 Slurry and unused VMB F1-ESC784-F6-01V-W in FAB1 CSF

Note: This project is registered under the Texas Accessibility Standards (TAS) program. TDLR registration is required for commercial and public facility construction to ensure compliance with accessibility requirements under Texas Government Code Chapter 469.