Equipment Pit 1.824
Equipment Pit 1.824 is a renovation/alteration project at 10100 Harry Ransom Trail, Austin, in Travis County, TX, tracked from its Texas Department of Licensing and Regulation (TDLR) registration. Construction complete (TDLR inspection passed Mar 2025). The project has an estimated value of $96K across about 430 sq ft.
📊Project Metrics
TDLR #TABS2025004708Project Closed
Project has been completed and closed
Equipment Pit 1.824 is a Renovation/Alteration project located at 10100 Harry Ransom Trail, Austin, TX 78758 in Austin, Texas. The project has an estimated value of $96K covering 430 sq ft. Nathaniel Atkins is the property owner and BSA LifeStructures is the design firm of record. The project was registered with TDLR on November 3, 2024.
❓Frequently Asked Questions
What is Equipment Pit 1.824?
Equipment Pit 1.824 is a renovation/alteration project at 10100 Harry Ransom Trail in Austin, Texas, registered with the Texas Department of Licensing and Regulation (TDLR). Scope of work: A 4' X 4' cut out of the concrete floor will be provided for a new piece of equipment. In addition, a hoist crane will be installed above the equipment. The project square footage is 430 sq/ft.
Is Equipment Pit 1.824 open in Austin?
Construction on Equipment Pit 1.824 is complete — TDLR records show the project passed its required accessibility inspection in Mar 2025. The building is finished and very likely open.
Where is Equipment Pit 1.824 located?
Equipment Pit 1.824 is located at 10100 Harry Ransom Trail, Austin, TX, 78758, in Travis County.
Who is the owner or developer of Equipment Pit 1.824?
Nathaniel Atkins is the property owner/developer of record for Equipment Pit 1.824, per its TDLR project registration.
Who is the architect or design firm for Equipment Pit 1.824?
BSA LifeStructures is the design firm of record for Equipment Pit 1.824, according to its TDLR filing.
How much does Equipment Pit 1.824 cost and how big is it?
Equipment Pit 1.824 has an estimated construction value of $96K and approximately 430 square feet (about $223/sqft), based on its TDLR filing.
📋Scope of Work
A 4' X 4' cut out of the concrete floor will be provided for a new piece of equipment. In addition, a hoist crane will be installed above the equipment. The project square footage is 430 sq/ft.
Note: This project is registered under the Texas Accessibility Standards (TAS) program. TDLR registration is required for commercial and public facility construction to ensure compliance with accessibility requirements under Texas Government Code Chapter 469.
📅Compliance Timeline
📅Project Timeline
Filed
Nov 3, 2024
Review Complete
Inspection Complete
Closed
Mar 10, 2025
🔗Related Projects
👤Same Owner
$6.9M total📄Related City Permits
Building permits found at or near this location
Replacement of complete existing central heat and air system with or without duct work **STEVE SERNA: Replace existing 2.5-ton vertical gas split system like-for-like; no structural change.
Install Inground Prefabricated Pool w/Spa ELECTRIC HEAT NO PP REQUIRED Concrete Decking Remove/Demo Existing Above Ground Pool and Wood Deck
Install Inground Prefabricated Pool w/Spa ELECTRIC HEAT PP REQUIRED Concrete Decking Remove/Demo Existing Above Ground Pool and Wood Deck
EV charger installation. install 60 AMP 240 Volt breaker in the main panel using an available slot. Route branch circuit directly behind the main panel and hard wire the GM power up 2 onto the interior side wall of the garage. The charger will be installed on a 60-amp circuit and will draw up to 48 amp continuous.
Request to disconnect Add 125 amp main to existing panel Per EC: they will not be upgrading anything as the existing service can handle the addition of the 125 amp