Final inspection completed, awaiting project closure
Enovis is a Renovation/Alteration project located at 2105 Scottsdale Dr, Cedar Park, TX 78641 in Cedar Park, Texas. The project has an estimated value of $3.5M covering 101,303 sq ft. Riverside is the property owner and GMA Architects, P.A. is the design firm of record. The project was registered with TDLR on April 28, 2025.
Tenant Improvement to existing building.
Note: This project is registered under the Texas Accessibility Standards (TAS) program. TDLR registration is required for commercial and public facility construction to ensure compliance with accessibility requirements under Texas Government Code Chapter 469.
Filed
Apr 28, 2025
Review Complete
Apr 28, 2025
Inspection Complete
Dec 18, 2025
Closed
234d
Construction phase
Building permits found at or near this location
1) Remove load bearing walls. 2) Relocate an existing approximately 21 in x 21 in x 60 in 4-ton air-conditioning unit from its current location to the attic space remove old ductworks and install new ductworks throughout the house. 3) Relocate a tankless water heater to the attic. 4) Relocate washer plumbing hookups approximately 5 feet into the garage area. 5) Convert a previously converted garage room back to its original garage use. 6) Addition of rear covered patio and trellis.
1) Remove load bearing walls. 2) Relocate an existing approximately 21 in x 21 in x 60 in 4-ton air-conditioning unit from its current location to the attic space remove old ductworks and install new ductworks throughout the house. 3) Relocate a tankless water heater to the attic. 4) Relocate washer plumbing hookups approximately 5 feet into the garage area. 5) Convert a previously converted garage room back to its original garage use. 6) Addition of rear covered patio and trellis.
1) Remove load bearing walls. 2) Relocate an existing approximately 21 in x 21 in x 60 in 4-ton air-conditioning unit from its current location to the attic space remove old ductworks and install new ductworks throughout the house. 3) Relocate a tankless water heater to the attic. 4) Relocate washer plumbing hookups approximately 5 feet into the garage area. 5) Convert a previously converted garage room back to its original garage use. 6) Addition of rear covered patio and trellis.
1) Remove load bearing walls. 2) Relocate an existing approximately 21 in x 21 in x 60 in 4-ton air-conditioning unit from its current location to the attic space remove old ductworks and install new ductworks throughout the house. 3) Relocate a tankless water heater to the attic. 4) Relocate washer plumbing hookups approximately 5 feet into the garage area. 5) Convert a previously converted garage room back to its original garage use. 6) Addition of rear covered patio and trellis.
*Partial Demo* Addition/interior remodel to single-story SFR
