Driftwood Business Park - Unit 10
Driftwood Business Park - Unit 10 is a new construction project at 10100 Darden Hill Rd Unit 10, Austin, in Hays County, TX, tracked from its Texas Department of Licensing and Regulation (TDLR) registration. Currently under construction. The project has an estimated value of $350K across about 5,000 sq ft.
📊Project Metrics
TDLR #TABS2025022004Review Complete
Design review complete, construction may proceed
Driftwood Business Park - Unit 10 is a New Construction project located at 10100 Darden Hill Rd Unit 10, Austin, TX 78737 in Austin, Texas. The project has an estimated value of $350K covering 5,000 sq ft. Linds and Dylan LLC series DBP 8 is the property owner and PQ Design is the design firm of record. The project was registered with TDLR on June 25, 2025.
❓Frequently Asked Questions
What is Driftwood Business Park - Unit 10?
Driftwood Business Park - Unit 10 is a new construction project at 10100 Darden Hill Rd Unit 10 in Austin, Texas, registered with the Texas Department of Licensing and Regulation (TDLR). Scope of work: construction of metal warehouse 5000 sq ft
Is Driftwood Business Park - Unit 10 open in Austin?
Driftwood Business Park - Unit 10 is currently under construction in Austin, TX. Its current TDLR status is "Review Complete".
Where is Driftwood Business Park - Unit 10 located?
Driftwood Business Park - Unit 10 is located at 10100 Darden Hill Rd Unit 10, Austin, TX, 78737, in Hays County.
Who is the owner or developer of Driftwood Business Park - Unit 10?
Linds and Dylan LLC series DBP 8 is the property owner/developer of record for Driftwood Business Park - Unit 10, per its TDLR project registration.
Who is the architect or design firm for Driftwood Business Park - Unit 10?
PQ Design is the design firm of record for Driftwood Business Park - Unit 10, according to its TDLR filing.
How much does Driftwood Business Park - Unit 10 cost and how big is it?
Driftwood Business Park - Unit 10 has an estimated construction value of $350K and approximately 5,000 square feet (about $70/sqft), based on its TDLR filing.
📋Scope of Work
construction of metal warehouse 5000 sq ft
Note: This project is registered under the Texas Accessibility Standards (TAS) program. TDLR registration is required for commercial and public facility construction to ensure compliance with accessibility requirements under Texas Government Code Chapter 469.
📅Compliance Timeline
📅Project Timeline
Filed
Jun 25, 2025
Review Complete
Jun 25, 2025
Inspection Complete
Closed
🔗Related Projects
👤Same Owner
$1.4M total📄Related City Permits
Building permits found at or near this location
Replacement of complete existing central heat and air system with or without duct work **STEVE SERNA: Replace existing 2.5-ton vertical gas split system like-for-like; no structural change.
Install Inground Prefabricated Pool w/Spa ELECTRIC HEAT NO PP REQUIRED Concrete Decking Remove/Demo Existing Above Ground Pool and Wood Deck
Install Inground Prefabricated Pool w/Spa ELECTRIC HEAT PP REQUIRED Concrete Decking Remove/Demo Existing Above Ground Pool and Wood Deck
EV charger installation. install 60 AMP 240 Volt breaker in the main panel using an available slot. Route branch circuit directly behind the main panel and hard wire the GM power up 2 onto the interior side wall of the garage. The charger will be installed on a 60-amp circuit and will draw up to 48 amp continuous.
Request to disconnect Add 125 amp main to existing panel Per EC: they will not be upgrading anything as the existing service can handle the addition of the 125 amp
Property Owner
Design Firm
Registered Accessibility Specialist
Hays County Economy
Explore Area
Find Professionals
Need a contractor for this project?
Browse verified general contractors active in Hays County
Find General Contractors in Hays