Dell PS4-1 Shock and Vibe Lab Equipment Replacement
Dell PS4-1 Shock and Vibe Lab Equipment Replacement is a renovation/alteration project at 12500 Tech Ridge Blvd, Austin, in Travis County, TX, tracked from its Texas Department of Licensing and Regulation (TDLR) registration. Currently under construction. The project has an estimated value of $175K across about 5,637 sq ft.
📊Project Metrics
TDLR #TABS2025012047Review Complete
Design review complete, construction may proceed
Dell PS4-1 Shock and Vibe Lab Equipment Replacement is a Renovation/Alteration project located at 12500 Tech Ridge Blvd, Austin, TX 78753 in Austin, Texas. The project has an estimated value of $175K covering 5,637 sq ft. Dell Technologies is the property owner and Cushing Terrell is the design firm of record. The project was registered with TDLR on February 17, 2025.
❓Frequently Asked Questions
What is Dell PS4-1 Shock and Vibe Lab Equipment Replacement?
Dell PS4-1 Shock and Vibe Lab Equipment Replacement is a renovation/alteration project at 12500 Tech Ridge Blvd in Austin, Texas, registered with the Texas Department of Licensing and Regulation (TDLR). Scope of work: Replacing equipment and related utility hookups including revision of equipment pits.
Is Dell PS4-1 Shock and Vibe Lab Equipment Replacement open in Austin?
Dell PS4-1 Shock and Vibe Lab Equipment Replacement is currently under construction in Austin, TX. Its current TDLR status is "Review Complete".
Where is Dell PS4-1 Shock and Vibe Lab Equipment Replacement located?
Dell PS4-1 Shock and Vibe Lab Equipment Replacement is located at 12500 Tech Ridge Blvd, Austin, TX, 78753, in Travis County.
Who is the owner or developer of Dell PS4-1 Shock and Vibe Lab Equipment Replacement?
Dell Technologies is the property owner/developer of record for Dell PS4-1 Shock and Vibe Lab Equipment Replacement, per its TDLR project registration.
Who is the architect or design firm for Dell PS4-1 Shock and Vibe Lab Equipment Replacement?
Cushing Terrell is the design firm of record for Dell PS4-1 Shock and Vibe Lab Equipment Replacement, according to its TDLR filing.
How much does Dell PS4-1 Shock and Vibe Lab Equipment Replacement cost and how big is it?
Dell PS4-1 Shock and Vibe Lab Equipment Replacement has an estimated construction value of $175K and approximately 5,637 square feet (about $31/sqft), based on its TDLR filing.
📋Scope of Work
Replacing equipment and related utility hookups including revision of equipment pits.
Note: This project is registered under the Texas Accessibility Standards (TAS) program. TDLR registration is required for commercial and public facility construction to ensure compliance with accessibility requirements under Texas Government Code Chapter 469.
📅Compliance Timeline
📅Project Timeline
Filed
Feb 17, 2025
Review Complete
Feb 17, 2025
Inspection Complete
Closed
🔗Related Projects
👤Same Owner
$16.3M total📄Related City Permits
Building permits found at or near this location
Replacement of complete existing central heat and air system with or without duct work hvac change out
This is a maintenance project removing the existing chilled water piping and replacing it with new piping in the same locations in preparation for an expanded chilled water system throughout the building at later phase.
Extensive irrigation system repair. Installation of 90+% of irrigation system. Connecting to existing backflow and water meter.
Construct new driveway approach of 17 FT and sidewalk of 35 LF ***Corner plot Stockton Ln is not accepted yet permit issued with just sidewalk on Saint Thomas Dr. Customer can get a separate standalone sidewalk permit with waiver once the final acceptance is being approved.
Cascade 330-T-R Is a New one-story single-family residence with (3) bedrooms (2) bathrooms an attached two-car garage and a covered entry porch and patio.